V0215, 6.14
Mark the current bend, in order to prepare it for another action, like move or swap. See
description below.
+Delete Bend
To delete the bend that is currently selected.
When a bend has been marked with the function key Mark Bend several other functions
become available:
+Move Bend
In the table overview of the bend sequence, it is possible to change the order of bends simply
by moving a bend to another place. Select the bend that must be moved. Then press the
button Mark Bend and the bend is highlighted. Now select the right place in the sequence.
When the correct bend is highlighted, press Move Bend. The bend will be inserted on the
current place.
+Swap Bends
With this command, two bends can change place in the bend sequence. Move the cursor to
one of the required bends and press the Mark Bend button. Then move the cursor to the bend
with which it must be swapped and press Swap Bends. If for any reason the action must be
cancelled, press the function Abort Mark during the procedure.
+Abort Mark
Remove the mark from the currently marked bend.
A bend is no longer marked when the mark is aborted, when an action is finished or when this
menu is left.
Copy Column
Copy the value of the currently selected parameter in the current bend to all other bends.
Turn Punch / Turn Die
Turn around the applied tool (back to front), as already explained earlier in this chapter. Only
available if the cursor is placed on a tool parameter or tool orientation parameter.
Gauge Func
Program the gauge positions, as already explained earlier in this chapter.
To Next Page
Loading...
