V0215, 1.8
angles can be optimized by the Value setting method. Just tap 2 times on the value of the line
length or angle to change and the keyboard will pop-up. The value can be entered in 2 ways
of confirmation:
• Enter function
• Enter-Next function
The Enter function will close the keyboard after entering the value. The Enter-Next function
will enter the value on the line or angle to change and the keyboard will remain opened for the
next programming step.
In case the typed value is erroneous, the “undo” button right from the input field can be tapped
to return to the original value or the backspace key on the keyboard to delete the last typed
character.
Zoom Function
By pinching the screen with two fingers simultaeously one can zoom in and out on the
drawing, tool or machine visualisation. By spreading fingers the system will zoom-in, by
bringing fingers nearer to each other the system will zoom-out.
Fit-To-Screen
In the command icons on the side of the screen you will find a Fit-To-Screen function. This can
be used when the drawing size is not clear in picture. Just tap once and the complete drawing
will be sized to fit the drawing screen.
Panning
A single finger will enable panning.
More information about this can be found in chapter 3.
Features of the drawing tool
• Graphical design of product shapes in 2D
• Scaled sheet thickness
• Auto scaling
• Horizontal and vertical projected dimensions can be entered
• Real scale tool design
• Single machine shape (pressbeam and table)
• Changing of lengths and angles
• Adding or deleting of bends
• Special bend features can be applied
• Hemming bends can be programmed
• Bumping bends can be used for big radius
• Existing products can be copied, changed and stored as a new product
• Closing dimension or highest precision tolerance selection
• Connecting 2D programs for 3D-production
1.5.4. Determine bend sequence
When the product drawing is completed, the control offers Tool setup mode to program the
exact tool set-up as it is organised on the machine. After this you can select the Bend
Sequence mode to determine and simulate the required bend sequence.
In the Bend Sequence mode, the control shows the product, the machine and the tools. In this
menu the bend sequence can be programmed and checked visually. When a bend sequence
has been determined, the CNC program can be generated.
To Next Page
Loading...
