V0215, 5.11
Minimum Y opening
During postprocessing of the programmed product, the control always computes an
optimal opening of the pressbeam to handle your product. Here you can program a
minimum required opening. The programmed value is the distance above the speed
change point (Mute).
5.4.3. Assignments - Backgauge possibilities
Backstop against sharp angle allowed
Specify if backstop may be placed against an angle smaller than 90°.
• No = not allowed
• Yes = allowed
Backstop-die, intermediate bend
Set to allow if there may be a bend between the die and backstop.
Selection possibilities:
• Permitted
• If unavoidable permitted: if it results that no solutions are to be found, than it is
permitted
To Next Page
Loading...
