V0215, 10.25
Tap Edit Drawing to make the backgauge drawing appear wherein the dimensions of the
backgauge finger can be programmed.
The following parameters describe the dimensions of the backgauge and the lay-on positions.
The number of parameters that has to be programmed depends on the number of gauge
positions. If more gauge positions are programmed, more parameters are offered. The
illustration at the bottom of the screen will change according to the number of gauge positions.
Finger height (FH)
The height (or thickness) of the first backgauge finger tip.
Finger length (FL)
The length of the first finger level.
Gauge height (H1/H3/H4)
The height of the different finger levels.
Gauge length (L2/L3)
The length of additional lay-on levels.
Gauge height (H2)
The height of the bottom of the gauge.
Gauge length (L1)
The length of the finger level at the bottom of the gauge.
To Next Page
Loading...
