Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the air shroud.
NOTE: For systems with 500W/1000W PSU only.
About this task
The following images indicate the location of the internal speaker and provide a visual representation of the removal procedure.
Figure 72. Removing the internal speaker
Steps
1. Disconnect the internal speaker cable from the connector on the system board.
2. Unroute the internal speaker cable through the recess on the chassis.
3. Slide and remove the internal speaker from the chassis.
Installing the internal speaker
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the internal speaker and provide a visual representation of the installation
procedure.
100
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
