Figure 25. Installing the M.2 2280 PCIe solid state drive
Steps
1. Align the notch on the solid state drive with the tab on the solid state drive connector.
2. Insert the solid state drive at a 45-degree angle into the slot on the system board.
NOTE:
When replacing a M.2 2230 solid state drive with a M.2 2280 solid state drive, ensure to move the standoff nut
to the M.2 2280 solid state drive slot position.
3. Replace the screw (M2x3.5) to secure the M.2 2280 solid state drive to the system board.
NOTE: Repeat the above procedure for installing the other solid state drive.
Next steps
1. Install the air shroud
NOTE: For systems with 500W/1000W PSU only.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the air shroud.
NOTE: For systems with 500W/1000W PSU only.
54 Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
