Dell D30M - Removing the processor fan and 65 W heat-sink assembly

To Next Page

To Previous Page

Figure 53. Installing the processor fan and 125 W heat-sink assembly

Steps

1. Align the screws on the processor fan and heat-sink assembly with the screw holders on the system board and place the

processor fan and heat-sink assembly on the processor.

NOTE: Ensure that the triangle mark is directed towards the rear side of the computer.

2. In the sequential order (1->2->3->4), tighten the captive screws to secure the processor fan and heat-sink assembly to the

system board.

NOTE: Tighten the screws in a sequential order (1,2,3,4) as printed on the system board.

3. Connect the processor-fan cable to the connector on the system board.

NOTE: Ensure to connect the cable to the corresponding connector with the same color on the system board.

Next steps

1. Install the air shroud.

NOTE: For systems with 500W/1000W PSU only.

2. Install the side cover.

3. Follow the procedure in after working inside your computer.

Removing the processor fan and 65 W heat-sink assembly

CAUTION: The information in this removal section is intended for authorized service technicians only.

Prerequisites

1. Follow the procedure in before working inside your computer.

Removing and installing Field Replaceable Units (FRUs)

Other manuals for Dell D30M