Figure 61. Front fan 2
Steps
1. Remove the M3x5 screw that secures the fan 1 to the chassis.
2. Disconnect the fan cables from the connectors on the system board.
3. Press the tab to release the chassis fan from the slot.
4. At an angle, lift the chassis fan and remove it from the chassis.
NOTE: Follow the procedure from step 2 to 4 for fan 2.
Installing the front fan
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the chassis fan and provide a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
89
To Next Page
Loading...
