Figure 65. Installing the rear fan for 300W PSU systems
Steps
1. Insert the rubber grommets on the chassis.
2. Align the slots on the fan with the rubber grommets on the chassis.
3. Route the rubber grommets through the slots on the fan and pull the rubber grommets until the fan snaps into position.
4. Connect the fan cable to the connector on the system board.
Next steps
1. Install the air shroud.
NOTE: For systems with 500W/1000W PSU only.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Removing the rear fan (1000W PSU)
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the air shroud.
NOTE: For systems with 500W/1000W PSU only.
About this task
The following images indicate the location of the chassis fan and provide a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs)
93
To Next Page
Loading...
