Figure 16. Removing the 3.5-inch hard drive assembly from Bay 1
Steps
1. Disconnect the data and power cables from the 3.5-inch hard drive module.
2. Press the securing tabs to release the hard drive assembly from the chassis.
3. Slide the hard drive assembly away from the chassis.
Removing the 3.5-inch hard drive assembly (Bay-2)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the 3.5-inch hard drive assembly (Bay-2) and provide a visual representation of the
removal procedure.
Removing and installing Customer Replaceable Units (CRUs)
45
To Next Page
Loading...
