● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, and the quantity of screws,
and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 25. Screw list
Component Screw type Quantity Screw image
Side cover Captive screw 1
M.2 2230/2280 solid state drive M2x3.5 1
WLAN card M2x3.5 1
WLAN Internal antenna M3x3 2
Power supply unit cover #6-32 2
1000W Power supply unit #6-32 4
Processor fan and 125W heat-
sink assembly
Captive screw 4
Processor fan and 65W heat-
sink assembly
Captive screw 4
VR heat sink Captive screw 2
Front fan 1 M3x5 1
Rear fan (1000W PSU) M3x5 1
System board #6-32
M2
10
2
34 Working inside your computer
To Next Page
Loading...
