Figure 67. Installing the rear fan (1000W PSU)
Steps
1. Align and place the system fan into the chassis.
2. Connect the fan cable to the connector on the system board.
3. Replace the M3x5 screw to secure the system fan to the chassis.
Next steps
1. Install the air shroud.
NOTE: For systems with 500W/1000W PSU only.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Power button
Removing the power button
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the air shroud.
NOTE: For systems with 500W/1000W PSU only.
Removing and installing Field Replaceable Units (FRUs) 95
To Next Page
Loading...
