About this task
The following images indicate the location of the wireless card and provide a visual representation of the removal procedure.
Figure 26. Removing the WLAN card
Steps
1. Remove the (M2x3.5) screw that secures the WLAN card to the system board.
2. Lift the WLAN card bracket away from the WLAN card.
3. Slide and remove the WLAN card from the connector on the system board.
4. Disconnect the antenna cables from the WLAN card.
Installing the WLAN card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the wireless card and provide a visual representation of the installation procedure.
Removing and installing Customer Replaceable Units (CRUs)
55
To Next Page
Loading...
