Dell D30M - Removing the powered GPU

Figure 39. Installing the graphics card
Steps
1. Lift the pull tab to open the PCIe door.
2. Remove the blank filler.
3. Align the graphics card with the PCI-express card connector on the system board.
4. Using the alignment post, connect the graphics card to the connector and press down firmly. Ensure that the card is firmly
seated.
5. Lift the pull tab to close the PCIe door.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Removing the powered GPU
Prerequisites
1. Follow the procedure in before working inside your computer.
68
Removing and installing Customer Replaceable Units (CRUs)