Figure 66. Removing the rear fan (1000W PSU)
Steps
1. Remove the M3x5 screw that secures the system fan to the chassis.
2. Disconnect the fan cable from the connector on the system board.
3. Remove the fan from the chassis.
Installing the rear fan (1000W PSU)
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the chassis fan and provide a visual representation of the installation procedure.
94
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
