Solid state drive
Removing the M.2 2230 PCIe solid state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the air shroud.
NOTE: For systems with 500W/1000W PSU only.
About this task
The following images indicate the location of the solid state drive (slot 2) and provide a visual representation of the removal
procedure.
Figure 22. Removing the M.2 2230 PCIe solid state drive
Steps
1. Remove the screw (M2x3.5) that secures the solid state drive to the system board.
2. Slide and lift the solid state drive off the system board.
Installing the M.2 2230 PCIe solid state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the solid state drive (slot 2) and provide a visual representation of the installation
procedure.
Removing and installing Customer Replaceable Units (CRUs)
51
To Next Page
Loading...
