Dell D30M - Removing the 3.5-inch hard drive bracket

Figure 17. Removing the 3.5-inch hard drive assembly (Bay-2)
Steps
1. Disconnect the data and power cables from the 3.5-inch hard drive module.
2. Press the securing tabs to release the hard drive assembly from the chassis.
3. Slide the hard drive assembly away from the chassis.
Removing the 3.5-inch hard drive bracket
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the 3.5-inch hard drive assembly (Bay-1).
About this task
The following images indicate the location of the 3.5-inch hard drive bracket and provide a visual representation of the removal
procedure.
46
Removing and installing Customer Replaceable Units (CRUs)