Figure 33. Installing the memory module
Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it secures into place.
NOTE: If the memory module is not secure, then remove the memory module and reinstall it.
Next steps
1. Install the air shroud.
NOTE: For systems with 500W/1000W PSU only.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
GPU end holder
Removing GPU end holder
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
NOTE:
The GPU end holder is an optional component that comes with certain discrete GPU configurations. It does not
come with integrated GPU configurations.
About this task
The following images indicate the location of the GPU end holder and provide a visual representation of the removal procedure.
62
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
