1. Install the power-supply unit.
WARNING: The cables and ports on the back of the power-supply unit are color-coded to indicate the different
power wattage. Ensure that you plug in the cable to the correct port. Failure to do so may result in damaging the
power-supply unit and/or system components.
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the installation
procedure.
Figure 47. Installing the power-supply unit cover
Steps
1. Slide the cover into the chassis until the securing tab snaps into position.
2. Replace the two (#6x32) screws to secure the cover to the power supply unit.
3. Connect the power cables to the connectors on the cover.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Removing the 1000W power-supply unit
Prerequisites
1. Follow the procedure in before working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
75
To Next Page
Loading...
