Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the air shroud.
NOTE: For systems with 500W/1000W PSU only.
About this task
The following images indicate the location of the rear fan and provide a visual representation of the removal procedure.
Figure 64. Removing the rear fan for 300W PSU systems
Steps
1. Disconnect the fan cable from the connector on the system board.
2. Locate the position of rubber grommets.
3. Gently pull the rubber grommets to release the fan from the chassis.
4. Remove the fan from the chassis.
Installing the rear fan for 300W PSU systems
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the rear fan and provide a visual representation of the installation procedure.
92
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
