NOTE: Note the routing of all cables as you remove them so that you can route them correctly while you are replacing the
power-supply unit.
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the removal
procedure.
Figure 46. Removing the power-supply unit cover
Steps
1. Lay the system on the right side.
2. Disconnect the power cables from the connectors on the cover.
3. Remove the two (#6x32) screws that secure the cover to the power-supply unit.
4. Slide the cover away from the chassis.
5. Lift the cover off the chassis.
Next steps
1. Remove the power-supply unit.
Installing the power-supply unit cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
74
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
