Figure 49. Removing the 1000W power-supply unit
Steps
1. Lay the system on the right side.
2. Disconnect the power cables from the connectors on the system board and unroute them from the routing guides on the
chassis.
3. Remove the four (#6x32) screws that secure the power-supply unit to the chassis.
4. Slide the power-supply unit away from the back of the chassis.
5. Lift the power-supply unit off the chassis.
Installing the 1000W power-supply unit
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
WARNING:
The cables and ports on the back of the power-supply unit are color-coded to indicate the different
power wattage. Ensure that you plug in the cable to the correct port. Failure to do so may result in damaging the
power-supply unit and/or system components.
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the installation
procedure.
Figure 50. Installing the 1000W power-supply unit
Removing and installing Customer Replaceable Units (CRUs)
77
To Next Page
Loading...
