Figure 15. Installing the air shroud
Steps
1. Align the air shroud over the heat-sink and system board holding and place it in the slot.
2. Press the air shroud down until the tabs secure into place.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
3.5-inch hard-drive assembly
Removing the 3.5-inch hard drive assembly (Bay-1)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the 3.5-inch hard drive assembly and provide a visual representation of the removal
procedure.
44
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
