Dell D30M - Installing the M.2 2280 PCIe solid state drive

Figure 24. Removing the M.2 2280 PCIe solid state drive
Steps
1. Remove the screw (M2x3.5) that secures the solid state drive to the system board.
2. Slide and lift the solid state drive off the system board.
NOTE: Repeat the above procedure for removing the other solid state drive.
Installing the M.2 2280 PCIe solid state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the solid state drive (Slots 1, 2, and 3) and provide a visual representation of the
installation procedure.
Removing and installing Customer Replaceable Units (CRUs)
53