Intrusion switch
Removing the intrusion switch
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the air shroud.
NOTE: For systems with 500W/1000W PSU only.
About this task
The following images indicate the location of the intrusion switch and provide a visual representation of the removal procedure.
Figure 70. Removing the intrusion switch
Steps
1. Disconnect the intruder switch cable from the connector on the system board and unroute the cable from the routing guide.
2. Slide and remove the intrusion switch from the chassis.
Installing the intrusion switch
CAUTION: The information in this installation section is intended for authorized service technicians only.
98 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
