About this task
The following images indicate the location of the power button and provide a visual representation of the installation procedure.
Figure 69. Installing the power button
Steps
1. Insert the power-button cable into the slot from the front-side of the computer, and press the power-button head until it
secures into the place in the chassis.
2. Align and connect the power-button cable to the connector on the system board.
Next steps
1. Install the air shroud.
NOTE: For systems with 500W/1000W PSU only.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
97
To Next Page
Loading...
