About this task
The following image indicates the location of the VR heat sink and provide a visual representation of the installation procedure.
Figure 59. Installing the VR heat sink
Steps
1. Remove the liner behind the VR heat-sink modules.
NOTE:
Step one is only applicable for a new installation or an upgrade. For replacing an existing component, follow the
procedure from step two.
2. Adhere the VR heatsinks to the system board.
3. Tighten the four captive screws that secure the VR heat sinks to the system board.
Next steps
1. Install the 125 W heat-sink assembly or 65 W heat-sink assembly.
2. Install the air shroud.
NOTE: For systems with 500W/1000W PSU only.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
87
To Next Page
Loading...
