Figure 53. Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
Next steps
1. Install the drive carrier.
2. If removed, install the front bezel.
Removing a 2.5-inch drive from a 3.5-inch drive adapter
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Remove the 3.5-inch drive adapter from the 3.5-inch drive carrier.
NOTE: A 2.5-inch drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch drive carrier.
Steps
1. Using a Phillips 2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
NOTE:
If the drive carrier has Torx screw, use Torx 6 screwdriver to remove the drive.
2. Remove the 2.5-inch drive from the 3.5-inch drive adapter.
62
Installing and removing system components
To Next Page
Loading...
