Figure 65. Installing the drive bay cage blank
Next steps
1. If removed, install the front bezel.
2. Follow the procedure listed in After working inside your system.
Removing a drive bay
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system.
3. Remove all the drives.
4. Remove the backplane from drive bay.
Steps
1. Using the Phillips 2 screwdriver, remove the screws securing the drive bay to the system.
2. Slide the drive bay out of the system.
NOTE: The procedure to remove the drive bays is similar for all configurations.
72 Installing and removing system components
To Next Page
Loading...
