FTOS Service Agent | 495
action-list
c e
Specify an action list for the associated policy and enter the conf-call-home-actionlist-name mode.
Syntax
[no] action-list word
Parameters
Defaults
none
Command Modes
config-callhome-policy-name
Command
History
Usage
Information
You access this command by first using the policy-action-list command to define a policy-action list
name and executing the policy command. Associate this action list to a selected test list through the
policy command. When any event occurs that is monitored by the associated test list, the policy
invokes the action list that you select here.
Related
Commands
admin-email
c e
Enter the Administrator email address, the address from which FTSA emails are addressed.
Syntax
admin-email email_address
To remove the Administrator’s email address, use the no admin-email command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf-callhome)
Command
History
Usage
Information
The domain name part of the email address can be specified here or by using the command
domain-name. In either case, if you specify a domain name by using the domain-name command,
that name will be used for the email address instead of a domain name that you might enter here.
word
Enter the keyword action-list followed by the name of a configured policy action
list.
Version 7.7.1.0 Introduced on C-Series and E-Series
default-action Select the information collection action that matches the selected test group.
policy Create a policy with a name and enter config-callhome-policy-name mode.
policy-action-list Name a policy action list and enter the config-callhome-actionlist mode to execute the
default-action command.
test-list Enter the name of a configured policy test list.
email address
You have two choices:
• Enter the administrator’s full email address, for example,
admin@domain_name.com.
• Enter just the username component, for example, admin.
Version 7.6.1.0 Introduced for C-Series
Version 6.3.1.0 Introduced for E-Series
To Next Page
Loading...
