Dell Force10 TeraScale E Series - Page 524

524 | FTOS Service Agent
www.dell.com | support.dell.com
test-list
c e
Enter the name of a configured test list to be associated with the selected policy.
Syntax
test-list word
Parameters
Defaults
No default behavior or values
Command Mode
config-callhome-policy-name
Command
History
Usage
Information
Executing the policy-test-list command puts you in the config-callhome-testlist mode, where you
use this command to invoke one of three possible test groups. FTOS monitors the system for any event
in the selected test group. If such an event occurs, FTOS invokes the action you defined using the
default-action command and then associate in this policy with the action-list command.
Related
Commands
word Enter the keyword test-list followed by the name of a configured test list.
Version 7.7.1.0 Introduced on C-Series and E-Series
Table 19-1. FTSA Test Sets
Hardware test set Software test set Exception test set
SFM status transition from active to other
state
SWP Timeout CPU usage more than 85%
Line card transition from active to other
state
IPC Timeout System crash
Port-pipe error or transition to down IRC Timeout Task crash
RPM status transition from active to other
state
CPU usage more than 85% Dump, reload due to error, RPM
failover due to error
PEM transition from up to other state Memory usage more than 85%
AC power supply transition from up to
other state
Fan tray down or individual fan down
Overtemp of any item listed in
show
environment
Over/under-voltage of any item listed in
show environment
action-list Specify a policy action list for the associated policy and enter the
conf-call-home-actionlist-name mode.
case-number Specify a case number for the associated policy.
dampen Set a delay before sampling for a test condition again after it has been matched.
policy Create a policy name and enter config-callhome-policy-name mode.
policy-test-list Name a policy test list and enter the config-callhome-testlist-name mode.