Dell Force10 TeraScale E Series - Page 817

IPv6 Border Gateway Protocol (IPv6 BGP) | 817
show ip bgp ipv6 unicast peer-group
c e
Allows you to view information on the BGP peers in a peer group.
Syntax
show ip bgp ipv6 unicast peer-group [peer-group-name [summary]]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
show ip bgp ipv6 unicast summary
c e
Allows you to view the status of all BGP connections.
Syntax
show ip bgp ipv6 unicast summary
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 27-10. show ip bgp summary Command Example
peer-group-name
(OPTIONAL) Enter the name of a peer group to view information about that peer
group only.
summary (OPTIONAL) Enter the keyword summary to view status information of the
peers in that peer group.
The output is the same as that found in show ip bgp ipv6 unicast summary
command
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 7.4.1.0 Introduced on E-Series TeraScale
neighbor peer-group (assigning peers) Assign peer to a peer-group.
neighbor peer-group (creating group) Create a peer group.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 7.4.1.0 Introduced on E-Series TeraScale
FTOS#show ip bgp ipv6 unicast summary
BGP router identifier 5.5.10.4, local AS number 100
BGP table version is 12, main routing table version 12
2 network entrie(s) and 4 paths using 536 bytes of memory
1 BGP path attribute entrie(s) using 112 bytes of memory
1 BGP AS-PATH entrie(s) using 39 bytes of memory
Dampening enabled. 0 history paths, 0 dampened paths, 0 penalized paths
Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx
5ffe:10::3 1 28 0 12 0 0 00:01:01 2
5ffe:11::3 1 27 0 12 0 0 00:00:55 2
FTOS#