Dell Force10 TeraScale E Series - Page 907

Link Layer Detection Protocol (LLDP) | 907
advertise med guest-voice
c e s
Configure the system to advertise a separate limited voice service for a guest user with their own IP
telephony handset or other appliances that support interactive voice services.
Syntax
advertise med guest-voice {vlan-id layer2_priority DSCP_value} | {priority-tagged
number}
To return to the default, use the no advertise med guest-voice {vlan-id layer2_priority
DSCP_value} | {priority-tagged number} command.
Parameters
Defaults
unconfigured
Command Modes
CONFIGURATION (conf-lldp)
Command
History
Related
Commands
advertise med guest-voice-signaling
c e s
Configure the system to advertise a separate limited voice service for a guest user when the guest voice
control packets use a separate network policy than the voice data.
Syntax
advertise med guest-voice-signaling {vlan-id layer2_priority DSCP_value} |
{priority-tagged number}
To return to the default, use the no advertise med guest-voice-signaling {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id
Enter the VLAN ID.
Range: 1 to 4094
layer2_priority
Enter the Layer 2 priority.
Range: 0 to 7
DSCP_value
Enter the DSCP value.
Range: 0 to 63
priority-tagged number Enter the keyword priority-tagged followed the Layer 2 priority.
Range: 0 to 7
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series and E-Series
protocol lldp (Configuration) Enable LLDP globally.
debug lldp interface Debug LLDP.
show lldp neighbors Display the LLDP neighbors.
show running-config lldp Display the LLDP running configuration.
vlan-id
Enter the VLAN ID.
Range: 1 to 4094
layer2_priority
Enter the Layer 2 priority.
Range: 0 to 7