Drives 139
5
Disconnect the cable from the back of the media card reader and from the system board.
6
If you are not replacing the media card reader at this time, install the 3.5 inch drive insert (see
"Replacing Drive Inserts" on page 131). Contact Dell if you need a drive bay insert.
Installing a Media Card Reader
1
If you are installing a new drive or media card reader:
a
Remove the drive inserts (see "Removing Drive Inserts" on page 129).
b
Remove the four shoulder screws from the drive panel insert.
c
Pull to remove the 3.5 inch drive insert that should be installed in the drive bay.
To Next Page
Loading...
