Drives 197
When connecting and disconnecting a SATA data cable, hold the cable by the black connector at each
end.
Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product
Information Guide
.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the computer cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as
a foam pad, that will sufficiently cushion it.
Removing a Hard Drive
1
If you are replacing a hard drive that contains data you want to keep, back up your files before you
begin this procedure.
2
Check the documentation for the drive to verify that it is configured for your computer.
3
Follow the procedures in "Before You Begin" on page 21.
4
Remove the computer cover (see "Removing the Computer Cover" on page 168).
5
Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
6
Press in on the two blue securing tabs on each side of the drive and slide the drive up and out of the
computer.
NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and
the cable connectors.
7
Lift the drive out of the computer, careful not to pull the cables still attached to it.
To Next Page
Loading...
