Configuring System Information 149
Click Clear All Entries to remove all Host Name IP Mapping entries from the table.
Viewing Dynamic Host Entries Using CLI Commands
For information about the CLI commands that perform this function, see the
IP Addressing Commands
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you
use.
ARP Table
Use the ARP Table page to view ARP parameters for IP interfaces. The ARP table displays the correlation
between each MAC address and its corresponding IP address.
To display the ARP Table page, click System
→
IP Addressing
→
ARP in the tree view.
Figure 6-29. ARP Table
The ARP Table page contains the following fields:
•
IP Address
— The station IP address, which is associated with the MAC address filled in below.
•
MAC Address
— The station MAC address, which is associated in the ARP table with the IP address.
Table 6-18. Dynamic Host Entries Commands
CLI Command Description
show hosts Displays dynamic host entries that the switch has learned.
To Next Page
Loading...
