Configuring Routing 577
–OSPF Type-1
–OSPF Type-2
–RIP
•
Next Hop Interface
— The outgoing router interface to use when forwarding traffic to the destination.
•
Next Hop IP Address
— The outgoing router IP address to use when forwarding traffic to the next
router (if any) in the path towards the destination. The next router is always one of the adjacent
neighbors or the IP address of the local interface for a directly attached network.
Displaying the Best Routes Table Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• IP Routing Commands
The following table summarizes the equivalent CLI commands for this feature.
Route Entry Configuration
Use the Router Route Entry Configuration
page to add new and configure router routes.
To display the page, click Routing
→
Router
→
Route Entry Configuration in the tree view.
Figure 9-37. Router Route Entry Configuration
The Router Route Entry Configuration page contains the following fields:
Table 9-33. Best Routes Table Command
CLI Command Description
show ip route preferences Displays detailed information about the route preferences.
To Next Page
Loading...
