534 Configuring Routing
Neighbor Configuration
Use the OSPF Neighbor Configuration
page to display the OSPF neighbor configuration for a selected
neighbor ID. When a particular neighbor ID is specified, detailed information about a neighbor is given.
The information below is only displayed if OSPF is enabled and the interface has a neighbor. The IP
address is the IP address of the neighbor.
To display the page, click Routing
→
OSPF
→
Neighbor Configuration in the tree view.
Figure 9-13. OSPF Neighbor Configuration
The OSPF Neighbor Configuration page contains the following fields:
•
Interface
— Select the VLAN interface on which routing is enabled from the drop-down menu.
•
Neighbor IP Address
— Select the IP Address of the neighbor for which data is to be displayed.
•
Router ID
— A 32-bit integer in dotted decimal format that identifies the neighbor router.
•
Options
— The optional OSPF capabilities supported by the neighbor. The OSPF Options field is
present in OSPF Hello packets, Database Description packets, and all link-state advertisements. The
Options field enables OSPF routers to support (or not support) optional capabilities, and to
Table 9-12. OSPF Neighbor Table Commands
CLI Command Description
show ip ospf neighbor Displays information about OSPF neighbors.
To Next Page
Loading...
