Configuring Switching Information 373
Bind IP Subnet to VLAN
An IP Subnet to VLAN mapping is defined by configuring an entry in the IP Subnet to VLAN table, an
entry is specified through a source IP address, network mask, and the desired VLAN ID. The IP Subnet
to VLAN configurations are shared across all ports of the switch. There can be up to 64 entries configured
in this table.
Use the Bind IP Subnet to VLAN page to assign an IP Subnet to a VLAN.
To display the Bind IP Subnet to VLAN page, click Switching
→
VLAN
→
Bind IP Subnet to VLAN in
the tree view.
Figure 7-60. Bind IP Subnet to VLAN
The Bind IP Subnet to VLAN page contains the following fields:
•
IP Address —
Specifies packet source IP address.
•
Subnet Mask —
Specifies packet source IP subnet mask.
•
Bind to VLAN (1–4093) —
Specifies VLAN to which the IP Address is assigned.
Binding an IP Subnet to a VLAN
1.
Open the
Bind IP Subnet to VLAN
page.
2.
Enter the IP Address to bind to the VLAN.
3.
Enter the IP Subnet associated with the IP address.
Table 7-29. MAC - VLAN Binding Commands
CLI Command Description
vlan association mac Associates a MAC address to a VLAN.
show vlan association mac Displays the VLAN associated with a specific configured MAC address.
To Next Page
Loading...
