182 Configuring System Information
RADIUS Server Configuration
From the RADIUS Server Configuration page, you can add a new RADIUS server, configure settings for
a new or existing RADIUS server, and view RADIUS server status information. The RADIUS client on
the switch supports up to 32 named authentication and accounting servers.
To access the RADIUS Server Configuration page, click System
→
Management Security
→
RADIUS
Server Configuration in the tree view.
Figure 6-54. RADIUS Server Configuration
The RADIUS Server Configuration page contains the following fields:
•
RADIUS Server Host Address
— Use the drop-down menu to select the IP address of the RADIUS
server to view or configure. Click
Add
to display the Add RADIUS Server page used to configure
additional RADIUS servers.
Table 6-30. RADIUS Global Commands
CLI Command Description
radius-server attribute Sets the network access server (NAS) IP address for the RADIUS
server.
radius-server retransmit Specifies the number of times the software searches the list of
RADIUS server hosts.
radius-server timeout Sets the interval for which a switch waits for a server host to reply.
show radius-servers Displays the RADIUS server settings.
To Next Page
Loading...
