768 Configuring IP Multicast
•
Admin Mode
— Displays the administrative status of the selected PIM protocol on the system.
•
Data Threshold Rate
— If PIM-SM is selected as the protocol, shows the minimum source data rate in
Kbps above which the last-hop router switches to a source-specific shortest path tree.
•
Register Threshold Rate
— If PIM-SM is selected as the protocol, shows the minimum source data
rate in Kbps above which the Rendezvous Point router switches to a source-specific shortest path tree.
Viewing Global PIM Settings Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• PIM-DM or PIM-SM Commands
The following table summarizes the equivalent CLI commands for this feature.
PIM Interface Configuration
Use the PIM Interface Configuration
page to configure specific interfaces with PIM.
To display t he page, cli ck IPv4 Multicast
→
PIM
→
Interface Configuration or IPv6 Multicast
→
PIM
→
Interface Configuration in the tree view.
Figure 12-35. PIM Interface Configuration
The PIM Interface Configuration page contains the following fields:
Table 12-33. PIM Global Settings Summary Commands
CLI Command Description
show ip pimdm Displays system-wide information for PIM-DM.
show ip pimsm Displays the system-wide information for PIM-SM.
To Next Page
Loading...
