Configuring IP Multicast 731
Displaying the Next Hop Summary Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• DVMRP Commands
The following table summarizes the equivalent CLI commands for this feature.
Prune Summary
Use the Prune Summary
page to display or print the prune summary by Group IP.
To display the page, click IPv4 Multicast
→
DVMRP
→
Prune Summary in the tree view.
Figure 12-12. Prune Summary
The Prune Summary page displays the following fields:
•
Group IP
— The group address which has been pruned.
•
Source IP
— The address of the source or source network which has been pruned.
Table 12-11. DVMRP Next Hop Command
CLI Command Description
show ip dvmrp nexthop D
isplays the next hop information on outgoing interfaces for
routing multicast datagrams.
To Next Page
Loading...
