Dell PowerConnect 6224 - Configured Ipv6 Routes

676 Configuring IPv6
• OSPF Intra — The OSPF intra route preference value in the router. The default value is 110.
•
OSPF Inter — The OSPF inter route preference value in the router. The default value is 110.
•
OSPF External — The OSPF External route preference value in the router (OSPF Type-1 and OSPF
Type-2 routes). The default value is 110.
Configuring IPv6 Route Preferences
1. Open the IPv6 Route Preferences page.
2. Configure the default preference for each protocol.
3. Click Apply Changes .
Route preferences are configured for IPv6, and the device is updated.
Configuring IPv6 Route Preference Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• IPv6Routing Commands
The following table summarizes the equivalent CLI commands for this feature.
Configured IPv6 Routes
Use the Configured IPv6 Routes page to display selected IPv6 routes.
To display the page, click IPv6
→ IPv6 Routes → Configured IPv6 Routes in the tree view.
Table 10-29. IPv6 Route Preference Command
CLI Command Description
ipv6 route distance Sets the default distance (preference) for static routes.
show ipv6 route preference Shows the preference value associated with the type of route.