Cable and Port Information 53
Power Connection
1.
Using a 5-foot (1.5 m) standard power cable with safety ground connected, connect the power cable to
the AC main socket located on the rear panel.
2.
Connect the power cable to a grounded AC outlet.
3.
If you are using a redundant DC power supply, such as the RPS600 or EPS470, connect the DC power
cable to the DC socket located on the rear panel.
4.
Confirm that the device is connected and operating correctly by examining the LEDs on the front
panel.
For a complete explanation of the LEDs, see LED Definitions
Figure 3-5. AC Power Connection to PowerConnect 6200 Series
To AC power
source
To DC power
source
To Next Page
Loading...
