600 Configuring Routing
4.
Click
Apply Changes
.
The new configuration is saved, and the device is updated.
Removing a Tunnel
1.
Open the
Tunnels Configuration
page.
2.
Specify the tunnel to remove in the
Tunnel
drop-down menu.
3.
Click
Delete Tunnel
.
The tunnel is deleted, and the device is updated.
Configuring a Tunnel using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• Tunnel Interface Commands
The following table summarizes the equivalent CLI commands for this feature.
Tunnels Summary
Use the Tunnel s S u m m ary
page to display a summary of configured tunnels. To display the page, click
Routing
→
Tunnels
→
Summary in the tree view.
Table 9-42. Tunnel Commands
CLI Command Description
interface tunnel Enables the interface configuration mode for a tunnel.
tunnel destination Specifies the destination transport address of the tunnel.
tunnel mode ipv6ip Specifies the mode of the tunnel.
tunnel source Specifies the source transport address of the tunnel, either explicitly or
by reference to an interface.
To Next Page
Loading...
