Dell PowerConnect 6224 - DHCP Snooping Dynamic Bindings Summary

456 Configuring Switching Information
• IP Address — Specify a valid IP address for the binding rule.
Displaying the DHCP Snooping Static Bindings Summary Table
1. Open the DHCP Snooping Static Bindings Configuration page.
2. Click Show All .
The
DHCP Snooping Static Bindings Summary table displays.
Figure 7-122. DHCP Snooping Static Bindings Summary
Configuring DHCP Snooping Static Bindings With CLI Commands
For information about the CLI commands that perform this function, refer to the following chapter in
the
CLI Reference Guide :
• DHCP Snooping Commands
The following table summarizes the equivalent CLI commands for this feature.
DHCP Snooping Dynamic Bindings Summary
The DHCP Snooping Dynamic Bindings Summary lists all the DHCP snooping dynamic binding
entries learned on the switch ports.
To access the DHCP Snooping Dynamic Bindings Summary page, click Switching
→ DHCP Snooping →
Dynamic Bindings Summary in the navigation tree.
Table 7-69. DHCP Snooping Static Bindings Configuration Commands
CLI Command Description
ip dhcp snooping binding Configures a static DHCP Snooping binding.