138 | Using the System Setup Program
Enables BIOS to generate NMI when PCI-E uncorrectable
errors occur.
Indicates all DIMMs in the system are operating at 1.25
volts.
Sets frequency multiplier as maximum level.
Downgrades frequency multiplier one level.
Downgrades frequency multiplier two levels.
Downgrades frequency multiplier three levels.
Sets the QPI frequency runs at maximum speed.
Sets the QPI frequency runs at 4.800GT.
Sets the QPI frequency runs at 5.866GT.
Sets the QPI frequency runs at 6.400GT.
Sets the QPI frequency runs at 7.200GT.
Sets the QPI frequency runs at 8.000GT.
Controls the energy efficient policy as performance profile
to configure all necessary settings.
Default, controls the energy efficient policy as balance
profile to configure all necessary settings.
Controls the energy efficient policy as low power profile to
configure all necessary settings.
Disables the Direct Cache Access.
Enables the Direct Cache Access.
Requests a customized default of SETUP values on the
next boot.
To Next Page
Loading...
