Figure 87. Installing the processor retaining clip
3. Align the processor with processor retaining clip by using your fingers to press the retaining clip on all the four sides until it
clicks into place.
NOTE: Ensure that the processor is securely latched to the processor retaining clip.
Figure 88. Press the retaining clip on the four sides
4. If you are using an existing cold plate, remove the thermal grease on the cold plate by using a clean lint-free cloth.
5. Use the thermal grease syringe included with your processor kit to apply the grease in a thin spiral on the bottom of the cold
plate.
112
Installing and removing system components
To Next Page
Loading...
