Table 60. Connector descriptions for NVMe with H755 MX or H965i MX
From To
BP_PWR_1 (backplane power connector) SIG_PWR_0 (system board power connector)
BP_DST_PA1 (PCIe cable connector ) CTRL_SRC_PA1 (PCIe connector of H755 MX or H965i MX
controller card, cable marking CTRL_PA1)
BP_DST_PB1 (PCIe cable connector) CTRL_SRC_PA1 (PCIe connector of H755 MX or H965i MX
controller card, cable marking CTRL_PA1)
BP_DST_PA2 (PCIe cable connector ) CTRL_SRC_PB1 (PCIe connector of H755 MX or H965i MX
controller card, cable marking CTRL_PB1)
BP_DST_PB2 (PCIe cable connector ) CTRL_SRC_PB1 (PCIe connector of H755 MX or H965i MX
controller card, cable marking CTRL_PB1)
Front I/O module
This is a service technician replaceable part only.
Removing the front I/O module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system
3. Remove all the drives.
4. Remove the drive cage.
Steps
1. Releasing the blue latches, pull the blue strap to disconnect the front I/O module cable connected to the system board.
2. Using the Phillips #1 screwdriver, remove the screws that secure the front I/O module to the system.
3. Holding the front I/O module, remove the front I/O module along with the cable from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 91
To Next Page
Loading...
