Dinstar UC2000 - Page 45

UC2000 User Manual
40
Copyright @ 2011-2015 Dinstar
Parameter
Explanation
Name
The name of the FXS profile
Tone Group
The national standard of dialing tone, busy tone and ring tone
Digit Timeout (s)
The timeout value for dialing a digit of a telephone number. The default is
4 seconds.
Dial Timeout (s)
The timeout value for dialing the first telephone number after off-hook.
The default is 10 seconds.
Ring Timeout (s)
The timeout value for the ringing of the analog phones of the FXS port
when there are incoming calls
No Answer Timeout (s)
The timeout value for ending calls which go out through FXS port. When
the value is exceeded, the call will end and the caller will hear busy tone.
Flash Detection
Whether to execute flash detection; If flash detection is not executed, the
press on flash-hook won’t be processed.
DTMF Send Interval(ms)
The minimum interval between the sending of two DTMF tone
DTMF: Dual Tone Multi Frequency
DTMF Gain
Signal gain of DTMF
DTMF Duration (ms)
The minimum duration of a DTMF tone
CID Send Mode
Include FSK and DTMF
FSK: Frequency-shift keying
CID: Caller ID
Message Mode
Include SDMF and MDMF
Message Format
Include Display Name and CID, Only display Name, Only display CID
Send CID Before Ring
If it is enabled, the CID will be shown before ringing; otherwise, CID will
be displayed after ringing
Send CID After Ring(ms)
The interval between ringing and displaying of CID
Impedance
The impedance matched with analog phones
Polarity Reverse
If polarity reverse is on, call tolls will be calculated based on the changes
in voltage. If polarity reverse is off, you need to set the time to delay
offhook and call tolls will be calculated starting from the set time.
Dialplan
The rules for dialing